That makes more sense Derek. I'm have repeaters setup this way. The bandpass filter can probably be tuned for either receiver freq and it should work fine on the other. You could also get a 1:2 splitter to accomplish feeding each receiver. That way you wouldn't have to worry about the exact cable length.
73, Bryan N3ST -----Original Message----- From: ve5sd [mailto:[EMAIL PROTECTED] Sent: Tuesday, February 01, 2005 6:22 PM To: [email protected] Subject: [Repeater-Builder] reposting - single antenna, two receivers Hi, I reread my original post, it should read the following: I am looking to use a Sinclair Reslok Q3220E UHF duplexor (insertion loss of .5 dB and rejection of 65 dB) tuned to 444.975/449.975 mhz. I have a UHF Master 2 repeater (run 30 watts) and a spare UHF receiver. I plan to have one receiver tuned to 449.975, the second to 449.950. I also have a high Q bandpass filter. If I was to run after the duplexor the bandpass filter tuned to 449.9625, (then a low gain preamp) then a tee then 1/4 wave of feedline (take in account velocity factor) to each receiver would this work? Is there a better way to do this? The site is at a commercial broadcast site, antenna is at 300 feet (2 bay folded dipole) and is replacing an exec 2 repeater at the same site, which works quite well. Any ideas or suggestions? Derek - VE5SD Yahoo! Groups Links ___________________________________________________________________ The information contained in this message and any attachment may be proprietary, confidential, and privileged or subject to the work product doctrine and thus protected from disclosure. If the reader of this message is not the intended recipient, or an employee or agent responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited. If you have received this communication in error, please notify me immediately by replying to this message and deleting it and all copies and backups thereof. Thank you. Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
