Here we go again-Yaphooey put me in bounce status for no reason.
They said msg #11290 in radios-4-sale bounced. The last msg in the group
is 11153! dumb [EMAIL PROTECTED]
Kevin & Natalia wrote:
> HI All,
>
> I am setting up a Doug Hall Voter, with one main site, and 3 remotes.
> Then I was thinking, how can one make it, so that when a signal report is
> requested, it will give a reading from that remote.
> Looked through the manual, and could not find anything.
> So my question, is it possible to get some form of signal reading from the
> Voter as to the signal strength from that remote (Active RX).
> I can work out from the I-O lines how to program the controller to say Main,
> Remote 1 etc, but at this stage can only get a signal reading from the main
> RX, which is at the site.
>
> Thanks
>
> Kev.
>
Weeelll, ACC had a op-amp circuit that sampled the quieting on the
incoming signal and delivered a 0-5V analog output that could be
measured with one of the A/D inputs on the RC850. You might find that
circuit on the Link-Comm web site.
That's the only way to do it.
--
Jim Barbour
WD8CHL
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
