Anyone have any idea what length of coax I should run from the transmitter and receiver to the duplexer? I have a Sinclair Q2220E and freq of 147.225 Transmit.
Any info about this will be greatly appreciated.
Thanks in advance.
WA0VUS
Larry Kemper
Muscatine, Iowa
[EMAIL PROTECTED]
If the entire system is 50 ohms, then the length is immaterial.
Use quality coax (see Bob Dengler's message a few higher in
the list) with silver plated connectors (no nickel) and start
hooking things up.
Folks use magic lengths to compensate for non-50-ohm
environments, especially solid-state TXs, and to get the SWR
under control.....
there was a thread on Z-matchers a while back.... I'd really
like someone to consolidate all of that into an article for the
archives at www.repeater-builder.com ...
Mike WA6ILQ
Yahoo! Groups Links
- To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
- To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
- Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
