Answered directly...
At 06:47 AM 3/14/05 -0000, you wrote:
>
>
>
>> Adam, Are there any voltage test points on this radio in which
>you can test VCO? Also, are the front end coils the 4 in a row on
>the bottom of radio???
>
>Thanks again in advance!!!!
>
>
> Just go back and forth across the front end coils for best
>sensitivity
>> over the frequency spread you would like to have, and you are set
>to go.
>> You should also adjust the TX and RX VCO's - the RX should be set
>where it
>> gives best performance and sensitivity IN SCAN, or you will not
>receive
>> all your channels in scan mode correctly. There is also a mod for
>locking
>> the noise blanker on full time, that I created for my 1011's, and
>it works
>> well. Good luck...
>>
>>
>> At 05:01 AM 3/12/05 -0000, you wrote:
>> >
>> >
>> >
>> >I have a vertex ftl-1011 lowband radio that i tuned up to TX/RX on
>52
>> >MHZ. Does anyone have advice on how to adjust the front end for
>> >optimum RX?
>> >
>> >
>> >Thanks, Rob
>> >
>> >
>> >
>> >
>> >
>> >
>> >
>> >
>> >
>> >
>> >
>> >Yahoo! Groups Links
>> >
>> >
>> >
>> >
>> >
>> >
>> >
>> >
>>
>> - Adam -
>
>
>
>
>
>
>
>
>
>
>
>Yahoo! Groups Links
>
>
>
>
>
>
>
>
- Adam -
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
