RE: [Repeater-Builder] Syntor programming

Thu, 31 Mar 2005 21:49:47 -0800

Hi Andy What program do you use to generate the file?  I have a program from Roger Ries and have never done it before. I have the eeprom programmer just wanted someone who hopefully has the same software so I can compare thier immage with mine.
 
Thanks
 
tom n8ies
 
 
----- Original Message -----
From: Andy Brinkley
To: [email protected]
Sent: 3/31/2005 8:42:20 PM
Subject: RE: [Repeater-Builder] Syntor programming

 
Tom -
 
Contact me via e-mail, I can send you a hex file with the info you need.
 
Andy
--------------------------------------------------------------
NC Certified Firefighter III / Instructor II / EMT-A
FCC Licensed Technician / Amateur Call NC4AB / Echolink Node 5761
http://www.brinkleyelectronics.com

 
-----Original Message-----
From: Thomas Oliver [mailto:[EMAIL PROTECTED]
Sent: Thursday, March 31, 2005 9:34 AM
To: repeater-builder
Subject: [Repeater-Builder] Syntor programming

 
Anyone using Synpromw from Ries Labs?
 
I have some UHF Syntors 450 -470 and wanted to use them for links / repeaters  The generate program is a little confusing he has some test prom files in there but the one for UHF is up in the 450 - 470 range no ham freq's. Do I just replace the 450 freq's with ham freq's?  What about injection? I think it says hi side.  Does the vco need to be modded? More capacitors strapped in / out?  What about the  vco freq. offset?  The eeprom I am using is a 2816 I am only interested in getting them to transmit and receive on one freq. right now I know I have to fill up the bank with freq's.
 
Could someone who has this program and has used it to get into the ham bands generate a  .spd file for me to compare?  N8JI are you here?
 
I would like one file to be TX 449.575 RX  444.575    and one
 

                                                   TX 442.625  RX 447.625

 

tom n8ies

 

 

 


Yahoo! Groups Links

Reply via email to