I am connecting a MCC RC-1000V (Voice Option) controller to a Maxtrac
receiver on the main receiver input.
I have the Maxtrac programmed for a low output on PL receive.
I have verified this is working.
I have the signal from the Maxtrac connected to pin 6 on the DB 25.
I have verified P3 pin 7 follows the PL signal.
U1 pin 17 does not have the signal apearing on it.
If I pull U1 pin 17 low, and COS is true, with the controller in PL
receive mode the xmitter will key.
>From what I can see on the board, there is a difference between the
RC-1000 and the RC-1000V in this area. P3 pin 7 does not go directly
to U1 pin 17.
I have checked the schematic and board layout on the Repeater Builder
site. The schematic and board layout for the RC-1000V is not listed.
Can someone point me in the proper direction?
Thanks, Steve N4IRS
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
