I oops'ed on that one, my figures are wrong, tis what I get for not looking. Anyways, take that down to .008 and .13. Yes, it's about a 1/3 of what it used to be, and so long as the user of the system has a mild to soft spoken audio it works just fine, but if they hit beyond 3.2 Khz deviation it begins to clip. This move has really made me work this system out.
Mathew -----Original Message----- From: Gary Laforce [mailto:[EMAIL PROTECTED] Sent: Tuesday, April 05, 2005 3:06 PM To: [email protected] Subject: RE: [Repeater-Builder] Pl Audio from a Cat1000B and TS64 PL tone should be run at or around .55 to .7 KC anyway sounds like its working fine to me at 1.3KC you can hear the PL tone. Adjust to .65 KC and call it good Gary LaForce Chariton Valley TriStar Communications Columbia Service Department Supervisor 573.441.2224 Direct Shop line 573.442.1147 Main Business Line 573.449.8310 Shop Fax line [EMAIL PROTECTED] -----Original Message----- From: w9mwq [mailto:[EMAIL PROTECTED] Sent: Tuesday, April 05, 2005 1:51 PM To: [email protected] Subject: [Repeater-Builder] Pl Audio from a Cat1000B and TS64 Can anyone tell me, I am using a TS-64 tone board wired directly into the cat1000B controller, and for some reason the output of the tone is very weak, and that is with the pot turned all the way up. It is less than .800 KC and used to be about 1.3 before I changed the frequency of the repeater. Any suggestions what might have went wrong. Mathew Yahoo! Groups Links Yahoo! Groups Links Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/

