ok P902 PIN # 8 is freq 1 select pin 1 is located at the bottom right if you are look at it with the connection to the right and solder side down. Mastr II exciter
Pin 2 CG hi PIn 3 CG lo Pin 4 A- Pin 5 Mic Lo Pin 6 Mic hi PIn 7 Reg 10v Pin 8 F1 Select Pin 9 F2 Select Pin 10 F3 select Pin 11 F4 Select Pin 12 OSC 10V Pin 13 COMP Pin 14 F5 select Pin 15 F6 select Pin 16 F7 select Pin 17 F8 select this is for the 19D4238652G2 and G4 exciter board 406-512mhz you should be ok on the vhf also.. ----- Original Message ----- From: "Coy Hilton" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Friday, May 13, 2005 5:35 PM Subject: [Repeater-Builder] (unknown) It's Pin 8 of the exciter connector It took me about 10 seconds to look at the label inside a near by MASTRII. The label is not registered with the pins, so Count from left to right starting with the first pin on the left. If you really need to Know what pin on the ICOM it is just use your trusty OHM meter. I would tell you but I don't Know which ICOM or Which Exciter you have. 73 AC0Y --- In [email protected], N�ATH <[EMAIL PROTECTED]> wrote: > Hello Kevin or Eric ? Any luck yet on telling me what pin to ground on the mastr II mobile Icon > to get the transmitter to operate on channel 1. > I feel like I've been forgotten. > It is an 8 channel 100 watt vhf mobile - I have sent the numbers you requested. I think they are > correct. > > Dave / N�ATH Yahoo! Groups Links --- [This E-mail scanned for viruses at TNWEB LLC] --- [This E-mail scanned for viruses at TNWEB LLC] Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
