One of the systems I take care of uses a Mastr II in station configruation as
it's transmitter. Recently, a repeater went on the air that is 30 KHz above
our
operating frequency. If you are within about five miles of our site and are
monitoring on the new machines frequency, you can hear our repeater. It is
not distorted, and it does not have any other modulation on it. I have heard
this signal on a number of differnet rigs, and so have several other users, so
I don't think it is a problem with overload of my receiver or other
problems in
my equipment.
I am not using the station receiver in the repeater, but have an ICOM in
it, as
the only TX ICOM I had was an EC version. I am using the RX ICOM just to
provide the conpensation signal to the TX element.
I had a similar problem about a year ago with a spur 60 KHz above our carrier,
but it cleared up after I swapped the exciter and PA boards out.
I have not yet been to the site to check out anything yet, but just wondered
if this is a problem anyone else has seen. Thanks, and 73,
Kevin, K9HX
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
