Pull the vol and squelch knobs off -- flip the radio up - side - down.
At the rear -- the heat sink has a flat space .... insert flat blade screw
driver
and lift plastic off of tabs which are to the right and left of heat sink slot.
After you know how it works - you can lift with your fingers on most
without tools. The radio slides apart - out of plastic case. Re-istall on
plastic rails and radio "snaps" back together.
I used some for remote receivers and link transmitters.
PTT - COS audio in and out can all be done on the rear plug. You can
do a few mods on the audio section - and they will PASS PL tones.
You can monitor all remote receiver activity at the voter site and do
PL selection at the voter site.
Ron
On 22 Nov 2005 at 22:21, Nate Duehr wrote:
> Hi all,
>
> Not repeater related directly, but have run across a few Maxar 80's in
> storage and wondering what they are. Know zilch about Moto model
> numbers, and figured this group would have someone that knows.
>
> Model: D04TSA3300BK
>
> The box has a label that they're UHF 4W.
>
> Also if anyone remembers (yeah, I know they're THAT old)... how to get
> the darn cover off them, any hints there would be appreciated also.
>
> Nate WY0X
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
