Hello Kevin, thanks anyway...maybe if my unit is still not running in a few weeks I'll contact you again ;-)
73 Bernd DM5BM --- In [email protected], "Kevin & Natalia" <[EMAIL PROTECTED]> wrote: > > Bernd, > > I have to apologise. When I made the offer to do a program for you, I > thought I had my DOS computer, and the software here, at home. > However when I went to get it, I found that I had packed it all away for our > up-and-coming house move (in just over 2 weeks) > Sorry about that. > I do, however see others helping you out, so you should get some results. > > Regards > > Kevin, ZL1KFM. > > ----- Original Message ----- > From: "Bernd Maestling" <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Thursday, November 24, 2005 12:52 PM > Subject: [Repeater-Builder] Re: Help Tait T800 series 1 programming > > > > Hello Kevin, > > > > yes a file would be great. I need TX: 439.3875 and RX: 431.7875 > > Today I saw a picture of another T855 but it was different inside. > > The PCB were the DIP Switch and eprom is located is much bigger > > in my unit, maybe because of the additional channel switching > > speaker module. > > > > 73 > > Bernd > > DM5BM > > > > > > --- In [email protected], "Kevin & Natalia" > > <[EMAIL PROTECTED]> wrote: > >> > >> Bernd, > >> > >> I have the Tait T-800 series 1 software here, and I can check and > > send you a > >> file of your freq's required. > >> I have a T-800, which I reprogrammed a number of years ago, and did > > not have > >> any problems. > >> If there are any problems, I can always make a phone call to Tait, > > as there > >> are home based here in NZ. > >> > >> Regards > >> > >> Kevin. ZL1KFM. > >> > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
