Sounds good, I would be willing to try it, as I plan on using "n" connectors. Here is my e-mail address: [EMAIL PROTECTED]
Thanks, Jim ----- Original Message ----- From: "Joe" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Sunday, December 04, 2005 5:30 PM Subject: Re: [Repeater-Builder] Source for RF enclos >I have used old Polyphasor surge suppressors for RF tight boxes, look at: > > http://www.polyphaser.com/kommerce_productdetail.aspx?item=IS-PT50HN > > These are 4.25" long, 2.25" wide and 1.25" deep outside dimensions. They > are cast aluminum, so the inside dimensions will be less. I can't find > the > Hamtronics preamp I have, but I think it will fit inside. The case has 2 > N > female connectors, one on each end. I have a few of these around, you can > have one for the postage. > > 73, Joe, K1ike > > At 09:50 AM 12/1/2005 -0500, you wrote: >>I have a Hamtronics LNP VHF Preselector board. I would like to install >>it >>in a RF tight box. Checked with Hamtronics and they have no such item and >>no advise as to where to find one. I want to install the board in a metal >>box and have the antenna leads come out to two female N connectors, and a >>12 >>vdc through a feed-thru connector for power. Their is no room to install >>it >>within the receiver. >> >>Thanks, >> >>Jim, K8COP > > > > > > > > > Yahoo! Groups Links > > > > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
