Kevin, Are you saying that there's more than one serial board? The most recent list of RC-96 options lists only the FC-1 as one that involves serial data. The board that's plugged into the U-33 socket in my RC-96 measures 2.9 cm by 4.2 cm, and has one flying lead that is soldered to the rear of the CNTL RX jack at Pin 6. This pin is unassigned in the RC-96 manual.
If you have any information about this little board, please advise. 73, Eric Lemmon WB6FLY -----Original Message----- From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of Kevin Custer Sent: Monday, January 02, 2006 5:49 AM To: [email protected] Subject: Re: [Repeater-Builder] ACC RC-96 Controller (was GE-Mastr II Audio Problem) The FC-1 was not intended to be mounted inside the controller though.... Eric Lemmon wrote: >John, > >I just went through the RC-96 manual on Link's ACC Archives site, and I did >find the serial interface board that was made for the RC-96 and other >models. It's the FC-1 Frequency Control Board that ACC sold as an option >for $55. It was intended to allow channel selection and limited control of >the control receiver, including the Icom IC-22. > >73, Eric Lemmon WB6FLY > > >-----Original Message----- >From: John J. Riddell [mailto:[EMAIL PROTECTED] > >Eric, I don't think there ever was a serial board for the 96...it was touch >tone control only. The RC-850 has a serial bd. > > > Yahoo! Groups Links Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
