I haven't programmed my new NHRC4 MII yet. I've got the new software chip for mine, Version 3, and it does not use the hex code programming format.
Did you follow the instructions in the manual? It calls for an initialization procedure, followed by entering the access code. Then you enable the controller. Then you enter the codes as you described (releasing the key after each character). After each character, you should hear "OK" after the character programmed. You must end the programming with an End-of-Message command. At the beginning of the CW ID, I usually add a few space characters to add a little delay before the ID starts. There is an NHRC-4 Programming Information Generator at: http://www.nhrc.net/nhrc-4/nhrc4prog.php that might be helpful. 73, Joe, K1ike At 12:32 AM 2/21/2006 +0000, you wrote: >Hi > >not really feasable as I live in Liverpool UK. >I did email them a few days ago, but no reply, so far. >A point you maybe able to answer. When I program in >the CW ID from a mobile with dtmf mic, do I release the >key in between ie, pppp2A18, pppp2D36 etc > >Thanks > > >Steve > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
