Ken Arck wrote:
> Hi all,
> I will be interfacing a RC-210 to a Micor Compa-Station unified chassis
> arrangement in the near future...
>
> <---Hi Mike
>
> Needless to say, I've interfaced an RC210 to a unified chassis before. I
> used the method outlined here:
>
> http://www.ccdx.org/zedyx/mods/micorbas.htm
>
> It works well and was pretty easy to do and had the advantage of needing
> only the Station Control card (getting rid of the Squelch gate card is a
> major blessing in and of itself!)
>
> Ken
Anyone know why they felt they needed FET's on the COS and PL decode
outputs? Mine are just direct wired right into the controller (6K) and
they work perfectly...
And I used the PL disable transistor on the Stn Cntl card to turn the T1
element on and off. A couple of trace cuts and a wire or two does it,
and it leaves me with a switch (and light) on the front to disable the
tx. If the green light is on, the tx is off.
Oh, and I have a jumper on the backplane to feed audio either from the
rx direct or from the controller to the local speaker. (I was too lazy
to put a switch on the front)
--
Jim Barbour
WD8CHL
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
