Jeff DePolo wrote:
> 1. Hook up the sig gen to the port labeled "Tx" or "low pass". Hook up the
> receiver/detector to the "Rx" or "high pass" port. Terminate the antenna
> port with a good load.
Also (a side comment, hopefully helpful), do NOT replace "sig gen" in
Jeff's comments with a higher power transmitter.
When just starting out, the "safety rule" is, "Do NOT tune any duplexer
using high power, ever."
(Posted knowing that those hams without the proper test gear, sometimes
improvise... and "sig gen" is a conspicuously easy idea to replace with
"any transmitter" in most folks heads.
If you HAVE to go there, pad it down to what a signal generator would
put out. "Sig gen" should not ever be replaced with "transmitter" in
this instruction set.)
Bad juju awaits, if you go down that path.
Nate WY0X
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
