You will likely end up with an audible sound by using two signals at the same time. Let's say you use 77.0 Hz and 192.8 Hz. These are unrelated but you will still get the sum and difference frequencies coming out, which would give you around 115 Hz and 269 Hz. You might hear the one at 269. If you used two signals that were much closer, you could hear a slow beat note.
Also, depending on the kind of decoders you use, they may not be happy seeing another sub-audible tone present along with the desired one. After saying this, I bet someone will come along and tell you that it will work, and how to do it! Bob M. ====== --- Kevin & Natalia Mitchell <[EMAIL PROTECTED]> wrote: > Hi All, > > I am wanting to use one TX from our repeater site, > to link to two link RX's, these are on opposite > sides of the repeater. > I was thinking about having two different CTCSS > tones, one for each, and then having the TX generate > the two tones together. This way I can use one > freq., but still have some form of control over the > links by switching either, or both CTCSS tones > off/on as required. > > Any ideas, or comments on this setup would be > helpful > > Regards > > Kev. __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
