But, if you just have to do it. Contact Zetron for their wiring list to connect their out board multi tone repeater controller. Also you will find the CG decoder gets talked down by HAM talkies, most do not filter audio below 300 hz, and that with excessive deviation will talk down the GE decoder. There is a software flash code that will fix this problem, until you reprogram the repeater, then you will need to flash it again. ssb
On 5/7/06, Steve Bosshard (NU5D) <[EMAIL PROTECTED]> wrote:
I would very strongly (almost to caps) recommend you use the built in controller inherent in the M3. You get hang time, time out timer, dtmf on/off, and morse id just by programming. We have had one in service , W5LM for 6 or 7 years with one PA driver module failure. Best luck, Steve NU5D
On 5/7/06, Kevin Berlen, K9HX <[EMAIL PROTECTED]> wrote:Our club has located a surplus Mastr III base station,
and I am looking for info on interfacing an external
controller to it. TIA and 73,
Kevin, K9HX
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/--
Ham Radio Spoken Here.....NU5D
--
Ham Radio Spoken Here.....NU5D
YAHOO! GROUPS LINKS
- Visit your group "Repeater-Builder" on the web.
- To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
- Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
