On Wed, 10 May 2006 11:20:49 -0400, Eric Vincent wrote:
>Hello, I have many GE TMX-1000 UHF in my stock and I dont have sevrice
>manual.
The TMX-1000 (MRK-V) is basically the same as a UHF
Phoenix, and you can use that manual for the RF stuff.
>Any body can tell me if can I put the RX CG at off.
Push the monitor button, or program the radio without CG.
>Other troubles, when decode DTMF, the receiver mute all the time, like a bad
>CG decode.
We use them around here for RF links between repeaters
so I know they pass DTMF just fine. Does it only mute
during DTMF? Does it pass audio OK?
>I was made a lot of tests, fine tune the IF, discriminator. with no good
>result.
Out of the 15 or 20 of these radios that I have used, I've
never had to touch the IF section of the radio....you shouldn't
have to.
>Anybody know where can I find informations or downlodable PDF on the Web?
I have the complete service manual for the TMX-1000, but just
like normal GE stuff, is chock full of multi-page foldouts.
Copying or scanning would be a major PITA :)
If you want to get rid of some, give me a shout!
Tedd Doda, VE3TJD
Lazer Audio and Electronics
Baden, Ontario, Canada
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
