Bill, I have converted several of those units for use with an external controller, and they seem to work fine. Just put the switch on the panel in the position to disable the controller, and connect your external controller to the proper pins on the rear interface connectors on the left side of the rear of the front panel rack. You will need a manual to run down the pins, but I found everything there I needed. I think I might have used a couple of pins on a connector on the rear half of the new controller for one function, but don't remember what it was. Maybe it was receive audio? All the docs are available at the Repeater Builder LBI site if you do not have the manuals.
The GE controller needs to be left in place to control the transmit signals for the exciter, but otherwise no functions are used with the external controller. It is convenient to listen to local audio and use the transmit switch for local testing. 73 - Jim W5ZIT -----Original Message----- From: [EMAIL PROTECTED] To: [email protected] Sent: Tue, 19 Dec 2006 10:24 PM Subject: [Repeater-Builder] GE Mastr II Station Hi! Does anyone have repeater conversion info on the newer style GE Mastr II stations with the all in one controller, metering and speaker (19B234871). I have a VHF station I wish to convert but I would like to keep the local station controls, speaker, mic and metering. Thanks! Bill N6YMZ ________________________________________________________________________ Check Out the new free AIM(R) Mail -- 2 GB of storage and industry-leading spam and email virus protection.
