Steve,

I'm not quite clear on your repeater configuration...   You mention "our 
receivers" with receivers being plural.  Initially I thought you were 
describing remote receivers feeding a voter located at a single transmitter 
site, but then you said "assume 1 dB loss from the duplexer" hinting at a 
traditional single receiver / single transmitter duplexed repeater.

Lastly it occurred that you may have a hybrid configuration:  traditional 
duplexed receiver and transmitter supplemented with remote receivers.  That 
would explain the need to increase transmitter power to fill voids.

Could you elaborate?

Speaking from personal experience with a traditional duplexed VXR-5000, I would 
end up with terribly unbalanced coverage (as Eric describes) if I were to run 
in excess of 100 watts..


Doug


  ----- Original Message ----- 
  From: Stephen Liggett 
  To: [email protected] 
  Sent: Wednesday, December 27, 2006 7:11 PM
  Subject: [Repeater-Builder] Re: local club needs repeater amp


  Eric,

  You really can't comment much about our situation in regards to  
  needing an amplifier unless you know more about the circumstances-- 
  each repeater system is different. As I posted, our receivers FAR out- 
  perform the one transmitter. You can be near full-quieting on  
  receive, but get a choppy and low level transmit from the transmitter  
  site.

  Lets do some math. Assume 1 dB loss from the duplexer, 1/2 dB loss  
  from the isolator, and 1/2 dB loss from the feedline (all optimistic  
  values). Given that 3dB is a loss of 1/2 of the power, our 25 watt  
  transmitter gives about 12-15 watts at the top. Given location, etc,  
  that is simply not enough. There are plenty of moderately-wide  
  coverage repeaters, with a less than optimal transmitter site, that  
  have greatly benefitted from amplifiers that can give 150-200 watts  
  at the antenna.

  I am interested in the your other comment about the Vertex 5000  
  receiver. Its sensitivity measures out well, and there is never  
  intermod or desensitization, even with a high quality preamp. But,  
  since I am always looking for better receivers, what in particular is  
  bad about the Vertex, and what receiver do you think is "best"?

  steve

  WA4BVO




   
  Yahoo! Groups Links




Reply via email to