My first attempt, since I had the vhf/uhf radio on the bench already, I put the xtal in the 144.810 rx side of the radio, it did not work, I would have thought it should have at least received, even though I would have to retune the radio. I put a second xtal in, and got the same results. Until I was certain these xtals were bad, I put this unit aside and took one of the UHF receivers, (these are being used for voter receivers) and began to tune it up, based on the sugesstions of all those whom were helping. I was pulling hairs out getting nowhere. I put this one aside, went back to the crossband unit, and began the retune and they came into place. This is what makes me believe that the uhf receiver that I have will not handle the high side cut. Most likely, since I only need this one xtal, I will have to reorder the xtal cut for the low side. I already had three of the crystals for the remaining receivers. Mathew
Laryn Lohman <[EMAIL PROTECTED]> wrote: --- In Repeater-Builder@yahoogroups.com, Mathew Quaife <[EMAIL PROTECTED]> wrote: and boom, came to life. WHAT went boom? What exactly did you do that got your receivers working? Laryn K8TVZ __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com