I am in need of some help getting a MSR2000 repeater in service.
It is a Model # C73KSB-3105BT VHF.
I have the following boards installed with the following jumper settings
Station Control Module -TRN5321A
JU1 - in
JU3 - in
JU4 - out
JU5 - in
JU6 - in
JU7 - in
JU8 - in
JU9 - in
JU10 - in
JU11 - out
Squelch Gate - TRN5324A
JU1 - out
JU2 - out
JU3 - in
JU4 - in
JU5 - in
JU6 - in
JU7 - in
JU8 - in
JU9 - in
JU10 - in
JU11 - in
JU12 - out
JU13 - 2 sec
JU14 - PL
JU15 - PL
No relay on board and CR15 - out
DC Transfer - TRN5240A
JU1 - in
JU2 - out
JU3 - out
JU4 - out
R1 Audio - TRN9689APR
JU1 - out
JU2 - out
JU101 - in
JU102 - in
JU103 - out
JU104 - could not find
JU105 - in
CR1 - in
CR2 - out
CR106 - out
PL - TRN5073APR
103.5 & 127.5 reed installed
The receiver and exciter are tuned and the PA puts out 100+ watts when the mic
is keyed.
- The repeater transmits when the local mic is keyed.
- When in pl mode the repeater unsqueches and received transmission is heard
over local speaker with a transmission with proper pl tone.
- When pl is disabled the repeater unsqueches and received transmission is
heard over local speaker with a transmission that breaks the squelch level
setting.
- When the repeater breaks squelch in either of the previous situations from a
received signal it does not transmit.
Do the above settings look ok?
Any suggestion on what to try next?
My first guess would be some kind of logic problem or jumper setting on the
Squelch gate card. We have tried multiple combinations with no luck.
Thanks,
Bill
W4RVN
