Bill, Go get and print out my MSR-2000 to external repeater controller text from www.radiowrench.com/sonic
I talk about the proper jumpers that need to be in place on the modules and on the back plane. You don't need to do the external controller mod to use the jumper info I supply Yes it's probably a jumper issue on the squelch gate module. If you don't need the wire line dc control you might remove the DC transfer module only after first reading my text. Quick testing... set the Squelch Gate module for carrier squelch (the 2 wire lead jumpers). Make sure JU5 and JU6 are installed and see if the repeater operates carrier squelch. cheers, skipp > Bill Photinos <[EMAIL PROTECTED]> wrote: > > I am in need of some help getting a MSR2000 repeater in service. > > It is a Model # C73KSB-3105BT VHF. > > I have the following boards installed with the following jumper settings > > Station Control Module -TRN5321A > > JU1 - in > > JU3 - in > JU4 - out > JU5 - in > JU6 - in > JU7 - in > JU8 - in > JU9 - in > JU10 - in > JU11 - out > > Squelch Gate - TRN5324A > > JU1 - out > JU2 - out > JU3 - in > JU4 - in > JU5 - in > JU6 - in > JU7 - in > JU8 - in > JU9 - in > JU10 - in > JU11 - in > JU12 - out > JU13 - 2 sec > JU14 - PL > JU15 - PL > > No relay on board and CR15 - out > > DC Transfer - TRN5240A > JU1 - in > JU2 - out > JU3 - out > JU4 - out > > > R1 Audio - TRN9689APR > JU1 - out > JU2 - out > > JU101 - in > JU102 - in > JU103 - out > JU104 - could not find > JU105 - in > > CR1 - in > CR2 - out > CR106 - out > > PL - TRN5073APR > > 103.5 & 127.5 reed installed > > The receiver and exciter are tuned and the PA puts out 100+ watts when the mic is keyed. > > - The repeater transmits when the local mic is keyed. > > - When in pl mode the repeater unsqueches and received transmission is heard over local speaker with a transmission with proper pl tone. > > - When pl is disabled the repeater unsqueches and received transmission is heard over local speaker with a transmission that breaks the squelch level setting. > > - When the repeater breaks squelch in either of the previous situations from a received signal it does not transmit. > > Do the above settings look ok? > > Any suggestion on what to try next? > > My first guess would be some kind of logic problem or jumper setting on the Squelch gate card. We have tried multiple combinations with no luck. > > Thanks, > Bill > W4RVN >
