--- In [email protected], "twoway_tech" <[EMAIL PROTECTED]> wrote: > > Well, Speaking of EFJ PPLs, has anyone accually performed the repeater > mods that are descibed on the repeater builder page? I have done one > radio, but I am getting RF into the receiver. Jim Sharp (the author) > mentions putting a shield around Q1, but the transistors are not > labeled that way. I don't really see any EASY way to install any > shield that would do much good due to the trace layout on the board.
[snip] Haven't done one yet, but have been studying the docs and, according to the block diagram and schematic, the first RF amp is actually Q201. There is a picture of where to solder the shield in the "updated-ppl- board.doc" file, linked from the conversion page. It goes on the foil side of the board, almost dead-center side-to-side, about 1/4 of the way forward from the rear edge. George, KA3HSW / WQGJ413
