Well, keep me posted on your findings with these things... I have a few laying around that I already have Xtals for and want to get going. I'll let you know if I find anything new.
-Jordan --- In [email protected], "ka3hsw" <[EMAIL PROTECTED]> wrote: > > --- In [email protected], "twoway_tech" <jcarter@> > wrote: > > > > Well, Speaking of EFJ PPLs, has anyone accually performed the repeater > > mods that are descibed on the repeater builder page? I have done one > > radio, but I am getting RF into the receiver. Jim Sharp (the author) > > mentions putting a shield around Q1, but the transistors are not > > labeled that way. I don't really see any EASY way to install any > > shield that would do much good due to the trace layout on the board. > > [snip] > > Haven't done one yet, but have been studying the docs and, according to > the block diagram and schematic, the first RF amp is actually Q201. > There is a picture of where to solder the shield in the "updated-ppl- > board.doc" file, linked from the conversion page. It goes on the foil > side of the board, almost dead-center side-to-side, about 1/4 of the > way forward from the rear edge. > > George, KA3HSW / WQGJ413 >
