I believe it does - but that is only one connection, and I need to be able to bring in flat audio from the as well... I think what I'm going to do is use the PL generating properties of the GTX itself for now.
Mark - N9WYS -----Original Message----- From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of mch Sent: Tuesday, May 22, 2007 9:25 AM To: [email protected] Subject: Re: [Repeater-Builder] Stupid question Does the GTX have a flat audio in connection? (I don't recall if it does or not) Joe M. N9WYS wrote: > > OK - I'm sure you will all think this is a stupid question, but I need to > ask it anyway. (I'm having one of my "stupid moments".) > > I'm cobbling together a GTX and a MaxTrac for my 900 project, and I'm using > a Com-Spec TP-3200 as the controller. I need to connect the CTCSS output to > something, but all I have so far are the following connections on the two > radios: > > RX Radio (MaxTrac): COR > Audio OUT + > Audio OUT Gnd > > TX Radio (GTX): PTT > Audio IN + > Audio IN Gnd > > So where do I feed in the CTCSS signal from the TP-3200? The Audio IN + ?? > Or do I need to designate another pin on the GTX connector for this purpose? > > Thanks, > Mark - N9WYS
