It doesn't have both flat audio and mic audio for TX? Joe M.
N9WYS wrote: > > I believe it does - but that is only one connection, and I need to be able > to bring in flat audio from the as well... I think what I'm going to do is > use the PL generating properties of the GTX itself for now. > > Mark - N9WYS > > -----Original Message----- > From: Repeater-Builder@yahoogroups.com > [mailto:[EMAIL PROTECTED] On Behalf Of mch > Sent: Tuesday, May 22, 2007 9:25 AM > To: Repeater-Builder@yahoogroups.com > Subject: Re: [Repeater-Builder] Stupid question > > Does the GTX have a flat audio in connection? > (I don't recall if it does or not) > > Joe M. > > N9WYS wrote: > > > > OK - I'm sure you will all think this is a stupid question, but I need to > > ask it anyway. (I'm having one of my "stupid moments".) > > > > I'm cobbling together a GTX and a MaxTrac for my 900 project, and I'm > using > > a Com-Spec TP-3200 as the controller. I need to connect the CTCSS output > to > > something, but all I have so far are the following connections on the two > > radios: > > > > RX Radio (MaxTrac): COR > > Audio OUT + > > Audio OUT Gnd > > > > TX Radio (GTX): PTT > > Audio IN + > > Audio IN Gnd > > > > So where do I feed in the CTCSS signal from the TP-3200? The Audio IN + > ?? > > Or do I need to designate another pin on the GTX connector for this > purpose? > > > > Thanks, > > Mark - N9WYS > > > Yahoo! Groups Links > > >