Why would you ever want to do that? Unless you like destroying isolators. :>)
73 Gary K4FMX > -----Original Message----- > From: [email protected] [mailto:Repeater- > [EMAIL PROTECTED] On Behalf Of Steve S. Bosshard (NU5D) > Sent: Sunday, July 01, 2007 8:52 PM > To: [email protected] > Subject: Re: [Repeater-Builder] Cable formula > > That would be the typical installation, unless you install the isolator > at the output of the duplexer with the #1 (input) toward the TX > cavities, #3 (load) toward the receive cavities, and #2 port (output) > toward the antenna, used in place of the TEE fitting. Steve NU5D > > > [EMAIL PROTECTED] wrote: > > Doesn't the isolator typically installed at the transmitter output > > spin off any anything reflected from the duplexer (or the > > feedline) into it's load? > > > > > > In a message dated 7/1/2007 5:33:33 P.M. Pacific Daylight Time, > > [EMAIL PROTECTED] writes: > > > > But at some off frequency that is not 50+j0 > > that impedance is going to get transformed into something yet > > again by the > > time the cable reaches the transmitter. > > > > > > > > > > > > Yahoo! Groups Links > > >
