Hi Randy, Can't give you the details of the specific resistor requirements without knowing more about your specific controller mod... but I can tell you some tricks to try with the 10K Pots (controls) you have available.
You can place resistors in series with the pot leads to make the 10k pot a 25k value with slightly reduced center wiper lead adjustment range. If you place one 15k fixed resistor on one of the "outside" pot leads the control becomes a 25k pot with a wiper travel only over the 2/5th of it's normal range. If you place the resistor on one end the 2/5 range is on the low side, the other side the 2/5 range is on the high side. .... and you can center the pot wiper range by placing two (equal) 7.5 k resistors (or anything close) on each pot outside lead. The available 2/5 wiper range will be in the center of the entire 25k value. If you get the idea of ratios... placing resistors in series on the pot solder terminal outside leads in various combinations will give you the 2/5th (ratio) operation of a regular 25K pot. Normally in a repeater/base conversion (operation) you only need final adjustments well within a 2/5th range. So you can have a bit of free lunch in this example. The only small trick is to figure out where/how to best select and place the extra fixed resistor(s) onto the potentiometer outside solder posts/terminals. cheers, s. > In interfacing the Mitrek to a Controller it calls for 25k > pots for the Squelch and Volume controls along with a 3.3 > and 10k resistors. All I could round up here was 10k pots > which I read in one of the listings would work fine but it > never said anything about changing out the 3.3 and 10k resistors > for something differnt if the 10k pots was used. Can > someone set me straight, I have only had one pot of coffee > so far and it takes at least two to get me going. > Randy >
