I've made that mistake before! Drove me crazy until I finally figured it out.
Joe -------------- Original message ---------------------- From: Jim Brown <[EMAIL PROTECTED]> > Here is a thought - I got caught on this once upon a > time - the dip switches on the CTCSS board have to be > OFF in the indicated positions to decode the tone you > want - not ON as you would expect. > > 73 - Jim W5ZIT
--- Begin Message ---
Here is a thought - I got caught on this once upon a
time - the dip switches on the CTCSS board have to be
OFF in the indicated positions to decode the tone you
want - not ON as you would expect.
73 - Jim W5ZIT
--- Brian Romine <[EMAIL PROTECTED]com > wrote:
> Ok here's the deal, have a MASTR II Station
> converted to repeater
> operation, with the 19D432500G1 dip switch
> programmable PL Encode /
> Decode board. I cannot get this to decode a
> properly encoded PL
> signal, I have tried three other 19D432500G3 Rev C
> Decode only boards
> and they also will not decode.
>
> I have checked every jumper I can find in any
> applicable LBI's and yes
> I have changed the jumper settings on the 10v
> Regulator card as well
> all with no luck.
>
> It is like the receive audio is being routed around
> the PL board no
> matter if the board is in place or not.
>
> I am at my whits end here and would greatly
> appreciate any MASTR II
> guru's help.
>
> Thank you,
>
> Brian Romine
> KC5CAY
>
>
_____________________ _________ _________ _________ _________ _
Never miss a thing. Make Yahoo your home page.
http://www.yahoo.com/r/hs
--- End Message ---
