Did you ground the hang-up lead?
On 12/23/07, de W5DK <[EMAIL PROTECTED]> wrote: > > Brian, > > You described it as "not decoding" but then say the audio is "routed > around the PL board".????? > > > > So with the decoder installed can you roll the squelch open and still hear > the speaker? If so the decoder is not getting a signal to RX mute. > > > > Just to the right of where the decoder plugs in on the system audio board, > do you have a jumper from H41 to H42? > > > > 73 > > Don W5DK > > > > *From:* [email protected] [mailto: > [EMAIL PROTECTED] *On Behalf Of *Brian Romine > *Sent:* Friday, December 21, 2007 3:37 PM > *To:* [email protected] > *Subject:* [Repeater-Builder] MASTR II PL Not Working > > > > Ok here's the deal, have a MASTR II Station converted to repeater > operation, with the 19D432500G1 dip switch programmable PL Encode / > Decode board. I cannot get this to decode a properly encoded PL > signal, I have tried three other 19D432500G3 Rev C Decode only boards > and they also will not decode. > > I have checked every jumper I can find in any applicable LBI's and yes > I have changed the jumper settings on the 10v Regulator card as well > all with no luck. > > It is like the receive audio is being routed around the PL board no > matter if the board is in place or not. > > I am at my whits end here and would greatly appreciate any MASTR II > guru's help. > > Thank you, > > Brian Romine > KC5CAY > > >
