Yes I did, and NO it doesn't, but then I would not expect it to (at this point) since the Remote Base Xmt ON command is not being accepted. The real issue isn't why no PTT, but Why won't the RC-100 either accept the programming of 4066, or maybe why isn't it accepting the on command when sent?
--- In [email protected], [EMAIL PROTECTED] wrote: > > Did you check the logic level driving the PTT transistor ? > Does it change ? > > > -------------- Original message ---------------------- > From: "raritansailor" <[EMAIL PROTECTED]> > > Hi Folks, > > > > I have an MCC RC-100 that I've been using for the MADXRA 147.345 > > Repeater, here on the Panhandle of WV. Has been working just fine. > > > > We decided to add a remote base in order to link this repeater into a > > regional network. Everything hooked up fine, everything works fine, > > EXCEPT.... I can't seem to get Remote Base Xmit to turn on! Therefore > > no PTT to the link Xcvr. > > > > I've programmed the 4066 * code 25 times and whenever I use it, no xmit > > on! So as it stands I can turn remote base ON, get the 500Hz remote > > base tone, the Link Xcvr audio is being passed from the network to the > > 147.345 system, but you can't connect from the 147.345 repeater to the > > network cuz the "Xmit on", won't turn on, and the Link Xcvr gets no PTT. > > > > Any ideas folks? I DO program the 4066 * code with 0X where X is a "not > > restricted" single digit. I've tried several different digits. (as a > > side note ny * codes for "force ID", and "Remote base OFF" work just > > fine!). When I program the 4066 * code I DO get the RR in response. > > > > What am I missing? Anyone able to lend a suggestion? > > > > Thanks! > > > > Mike, N3EAQ > > > > > > > > > > > > > > Yahoo! Groups Links > > > > > > >
