I would need to see a manual to identify specific inputs as I am not a GTX guru.... My reply was more in generalities to help you hunt for what you need...What are the inputs you speak of labeled as??? Maybe we can sort it out??
and YES you always can cheat and let the GTX do encode.... my only complaint in doing that is the repeater controller can be set up to NOT encode during CW id, and make it quieter to users in off hours :-), but if the repeater transmitter sends tone all the time, it would be negated. Remote basing off a repeater that does not encode during hang time is also much easier.:-) In general I think most repeater operators like to only encode while decoding if that is an option.... Doug At 10:48 AM 2/2/2008, you wrote: >Doug, > >OK - so to simplify (if I understand this correctly) I should feed the "PL >Audio" into the GTX on Pin 11 and keep Voice Audio on Pin 2? > >Or even go more simply and just allow the GTX to generate the PL... Again - >I'm using a ComSpec TP-3200 as my controller. > >Thanks! >Mark - N9WYS
