Hello Larry - I reckon you didn't get any answers because maybe every one like myself didn't know the answer - I have oft wondered about this myself - I have had a DB-224 for years- bought it new and have had problems off and on for years with it - I have wondered if you drilled thru where the goo is installed at the obvious connection point and ripped the innards out - How would you know that they cleared? It seems it wouldn't show on an ohm meter, a loop open is still shorted, right? I don't have an answer yet but I am still waiting on the answer that maybe some one will give you - concerning an earlier post - Does that make me a troll? Is that what a person that reads but doesn't post much is called? Dave / NØATH
----- Original Message ----- From: Larry Wagoner To: [email protected] Sent: Saturday, September 13, 2008 12:39 PM Subject: [Repeater-Builder] DB 268 harness I sent this question recently and saw no responses - so I'll try again ... I have a DB 268 antenna - a 4-bay VHF dipole. It has the harness interior to the mast. I want to know if it is possible to replace that harness with an exterior one - like the DB 224 has. If so - any ideas on the process? Larry Wagoner - N5WLW -------------------------------------------------------------------------------- -------------------------------------------------------------------------------- No virus found in this incoming message. Checked by AVG - http://www.avg.com Version: 8.0.169 / Virus Database: 270.6.21/1669 - Release Date: 9/12/2008 2:18 PM
