DCFluX, That worked!
I lifted one side of R188 instead of going to the IC. CWID, courtesy beep and status tones are back and no more squelch tails with delayed audio. I'm not using the telephone patch anyway but Zetron did offer an audio delay for that feature. Randy WB0VHB --- In [email protected], DCFluX <dcf...@...> wrote: > > Looks like there is a delay plug in there, but it is only for the > phone patch audio for some reason. > > I'd recommend you remove the 4066 that is located at U35 and lift up > pin 4, Stick a wire in the socket and solder a wire to pin 4. The wire > going into the socket will be your RAD input and the wire to pin 4 > will be connected to RAD output. > > This will not delay the RX audio going into the phone line though. > > On Fri, Feb 6, 2009 at 6:11 AM, <ran...@...> wrote: > > Ken, > > > > That won't work either. > > > > I can't gate the receive audio since discriminator audio is fed to the > > panel to determine valid PL tone. > > > > I simply need to find a location inside the panel to break transmitted > > audio ahead of the CWID and status tone generation section. > > > > Randy > > WB0VHB > > > > > > >The RAD should be in the receiver audio path not the transmitter path > > > > > >Ken > > > > > >At 07:16 PM 2/5/2009, ran...@... wrote: > > > > > >I am using a Zetron Model 48B as a repeater controller. Everything is > > >going fine except my addition of a Arcom RAD audio delay board. The > > >board is working great except now the CWID and status tones are not > > >transmitted. > > > > > > ------------------------------------ > > > > > > > > Yahoo! Groups Links > > > > > > > > >
