Isn't that card a PL decoder card from a CR? I have a TLN4050SP19 from an EMS station that I made a few jumper changes to make it into the dual-squelch level thingy, controlling it with tones from the 7330. Hit a macro, squelch gets tight. Hit another, it goes to threshold.
Scott Zimmerman wrote: > They *would* if it was me doing the job. This is for the county's radio > system, so I need to do it "by the book." I mentioned about using some other > modules, but others involved were rather persistent that we use the right > cards. > > Scott > > Scott Zimmerman > Amateur Radio Call N3XCC > 474 Barnett Rd > Boswell, PA 15531 > > ----- Original Message ----- > From: "Mark" <n9...@ameritech.net> > To: <Repeater-Builder@yahoogroups.com> > Sent: Friday, March 13, 2009 11:26 AM > Subject: RE: [Repeater-Builder] Micor Card needed - TLN1251A > > >> Scott, >> >> I have six of the MICOR "Four User Control Module" - TLN1685A. >> >> Might these work for your application? Each reed has an Enable/Disable >> switch on the front of the card... >> >> Mark - N9WYS >> >> -----Original Message----- >> From: Repeater-Builder@yahoogroups.com On Behalf Of Scott Zimmerman >> >> I am in need of a few TLN1251 cards. These are more commonly known as >> "private line control modules." They have 2 momentary switches in the >> front >> labeled "Operate PL" and "Operate Carrier Squelch." >> >> They have 2 tone decoders on board - 1550 Hz and 1450 Hz. >> >> If you or anyone you know has any they don't need, let me know. >> >> Thanks, >> Scott