what I would do ... unplug the RIC .. and turn 1 radio off .. and power up .. if all is good turn the system off and turn the other radio on and power up .. if still good then power down plug the RIC in then power up the system up again ..
This will tell you A if there is a Problem with the RIC . B Power Supply Problem you say the Radios are good .. so I would point to the power supply .. if you have an AMP meter this will tell you what the system is drawing on the DC side .. ALSO check Fuses and have you read 12V on the power Cords of the radios ? Rick On Sun, Apr 5, 2009 at 7:45 PM, Brian Raker <[email protected]> wrote: > Hi All, > > I've recently acquired a CDR500 repeater and I'm in the process of > checking it out and making sure that everything works as best as I can > tell before reprogramming and repurposing it. However, I seem to have > run into a snag. > > The unit has two CDM750 403-470 4-channel radios, a 6-well duplexer > and a 4 well filter (I think, not relevant at the moment), and a RICK > (HLN3333B). When I power on the unit, the intake fan on the bottom > fires up, but nothing else seems to happen. No lights appear on the > radio faces, and the RICK doesn't do anything likewise. I've traced > the interface cables and they are plugged in right, the power cables > are good to the radios, and the radios are known good (used a tabletop > supply from a GM300 and 16-pin plug from the same GM300). I > unfortunately don't have or know of anything to test the RICK out > with. > > Does anyone have any suggestions on how to further test this unit out? > > Thanks! > > -Brian / KF4ZWZ > >
