I was just thinking about this, if the output on pin 1 is an open collector output you will not see a state change without a pull-up voltage. You may need to put a pull-up resistor to 12VDC to see the change.
73, Joe, K1ike Joe Landers wrote: > > > Hello Group > > > > Anyone out there using a alinco dr235t as a remote base? I am trying > to use one I have a plug wired for the 9 pin plug on the rear it shows > in the manual that pin 1 is the squelch signal output however I have > found no signal on that pin. I have tried it in packet mode and > non-packet mode and it does not show any reading. Anyone out there > that can give me a thought or 2 I would appreciate it . > > > > Joe Landers > > Ke4eue > > >