Hi everyone, I have a Motorola Quantar on the bench at the moment and I am having a slight issue with the programming of the unit. I have programmed plenty of these for public safety but this one is for amateur use on 70cm. The receiver, PA and exciter are all for UHF R1 (403-433Mhz) but the frequencies that need programming are: RX - 433.175 TX - 438.175 These are the base TX/RX values. When I program the codeplug in, I obviously get RX and TX errors showing up. Is there any way to trick the base into going a bit out of band to clear the errors? Normally I would just swap out the modules for the correct split and be done with it but this unit is a donation to the club and money for replacement modules isnt easy to come by. Thanks Greg
