Hi Greg, Don't know if it's relevant, but I just programmed one for the 2 meter band, and when I entered the freq's, it gave me an error message. Can't remember exactly what it was, but I entered 'no', and it continued on as if nothing was wrong.
Seems to work fine. Tim W5FN --- In Repeater-Builder@yahoogroups.com, Greg <gregm...@...> wrote: > > Hi everyone, > > I have a Motorola Quantar on the bench at the moment and I am having a slight > issue with the programming of the unit. I have programmed plenty of these for > public safety but this one is for amateur use on 70cm. > > The receiver, PA and exciter are all for UHF R1 (403-433Mhz) but the > frequencies that need programming are: > > RX - 433.175 > TX - 438.175 > > These are the base TX/RX values. When I program the codeplug in, I obviously > get RX and TX errors showing up. Is there any way to trick the base into > going a bit out of band to clear the errors? > > Normally I would just swap out the modules for the correct split and be done > with it but this unit is a donation to the club and money for replacement > modules isnt easy to come by. > > Thanks > > Greg >