I've actually seen that before on a Wacom. Go with silver bearing solder if you have it.
On Mon, Aug 10, 2009 at 11:19 AM, tahrens301<[email protected]> wrote: > Hi Ralph, > > No, they were 10" as came from the factory for 166 mhz, > so it didn't look like they were cut for anything > in particular. > > DCflux - I started to do what you suggested... sounded > like something else to try. Took the link out of the > last can & the loop wasn't soldered to the PL259 connection. > Only a solder blob on the end of the pin. I could push > on the link & it would freely move on the pin. NOT GOOD! > > Think I'll pull them all out & have a look - I found one > like this earlier in the other side. Guess it was built > on a Monday! haha > > Thanks, > > Tim > > > > > > ------------------------------------ > > > > Yahoo! Groups Links > > > >
