Hi everybody! some valuable help is needed. i have the RF tray and the controller on the top of it SSCB digital capable only (the unit with the led's) 800 mhz C85CXB-5103BT. the RF tray is lacking the TX VCO and no cables with RCA ends no connector for stearing and power originaly to TX VCO, no IPA in the middle, the UNI-BOARD has 14.40000 mhz oscilator built in. i'd like to apply power from non original power supply to the interconnect board, what the molex is supposed to get red and white +14V and black and brown -14V, what about the blue orange and green? nothing powers up at this point, the 5V regulator on the interconnect board is working, i cheked the 9.6V test point and it has the voltage, the 5V check point at the SSCB has no voltage on it and thus no power up... J502A the 6 pin connector on the interconnect board takes what? 5mhz signal goes where? is this receiving station only, can i use it to transmit? how to get it to power up? what voltages i apply at the J603A, J701A, J502A, what the J500 and J501 are for? J596A? this info i can not find at repeater-builder. if you can hlep me please. thanks!
