TXRX sells a small tuning tool that makes the adjustment of the notches very 
easy. it's only about a dollar or so.
lance N2HBA
  ----- Original Message ----- 
  From: NORM KNAPP 
  To: [email protected] 
  Sent: Sunday, September 27, 2009 5:08 AM
  Subject: Re: [Repeater-Builder] TX/RX systems duplexers. WOW!!!


    I don't mean to sound dumb, but are you saying the VHF spec'd cans will 
work on UHF as well,
  I do have a couple of nits to pick with TX/RX about these cans however.
  1) BNC connectors?!?!?!
  2) It is next to impossible to get in there and tune the notches on 3 of the 
cans because of the location of the adjustment caps.
  3) Lack of a fine tuning for the pass rods. They slide in or out. No fine 
threaded adjustment for when you get them "close".

  Other than that, they seem great! I was going to turn them around and sell 
them, but I may part with a set of Q-202g's instead.

  73
  Norm

  ----- Original Message -----
  From: [email protected] <[email protected]>
  To: [email protected] <[email protected]>
  Sent: Sat Sep 26 23:20:17 2009
  Subject: RE: [Repeater-Builder] TX/RX systems duplexers. WOW!!!



  Hi Norm,



  I have two sets here, one new out of the box and a older unit but the same 
series of duplexer. I tuned them to tx447.125 & rx442.125 and experienced the 
same as you have found. I am using a HP8920 and my other unit is a HP8924. Both 
show the same so I would say your units are working.



  Mike





  Mike Mullarkey K7PFJ

  6886 Sage Ave

  Firestone, Co 80504

  303-954-9695 Home

  303-954-9693 Home Office & Fax

  303-718-8052 Cellular



  From: [email protected] 
[mailto:[email protected]] On Behalf Of NORM KNAPP
  Sent: Saturday, September 26, 2009 9:52 PM
  To: [email protected]
  Subject: [Repeater-Builder] TX/RX systems duplexers. WOW!!!





  I wound up with a set of Tx/RX 28-38-03-C vari-notch duplex today. I was not 
expecting much. I got them cheap. The cans are only 4". No big deal. Bigger 
cans = deeper notches with less insertion loss, right? Well, unless my site 
master and IFR-2945B are lying to me, I got -100db on the notches and 1.2 db 
insertion loss! I will say this, the coupling loops are very different than 
what I have seen in sinclair, telewave and db cans. Does anyone else have any 
experience with this model? Am I reading things right?
  All I got to say is, incredible!

  No virus found in this incoming message.
  Checked by AVG - www.avg.com
  Version: 8.5.409 / Virus Database: 270.13.113/2396 - Release Date: 09/26/09 
05:51:00




  


------------------------------------------------------------------------------



  No virus found in this incoming message.
  Checked by AVG - www.avg.com 
  Version: 8.5.409 / Virus Database: 270.13.113/2397 - Release Date: 09/26/09 
17:51:00

Reply via email to