How are/were the MIIe programmable values programmed?
s.
> DCFluX <dcf...@...> wrote:
>
> The MASTR-IIe is kinda a hybrid between the MASTR-II and MASTR-III.
>
> Essentially, The power supply and system card from the
> MASTR-III is used with MASTR-II RF hardware. The result is
> you get a repeater or base station with programable timers,
> morse code ID and PL/DPL tones, but still uses crystals to
> set the frequency. Word was this was done because they were
> waiting on type accepting the IIIs RF hardware and the rest
> of the III was ready to go and they needed something to sell.
>
> I don't know if GE marketed them, but you can mix and match
> the RF decks to create 10m, 6m and 1.25m MASTR-IIe's.
>
> The MASTR-III is only available on 2m, 70cm and 850 Commercial.
>
> I have seen people buy the IIe and revert it back to a II for reasons
> unknown by replacing the min-backplane for the full size one and using the
> standard 10V card.
>
> On Wed, Jan 6, 2010 at 9:31 AM, Bill Isom <bil.i...@...> wrote:
>
> >
> >
> >
> >
> >
> >
>
