thank you sir your a s star i have done the com2 aux hook already and do have the service manual and did see the part about the resistors but it was about 1am and i'd been starring at the radio for 8 hours
so thank you i will go through that again thought i was going mad i will let you know how i get on best regards phill h (M6TEE) bridlington east yourkshire uk --- In [email protected], "skipp025" <skipp...@...> wrote: > > > Re: The Kenwood TK-780 & TK-880 External PTT/Audio Input via > the KCT-19 cable/connector. > > Who's the nicest person you know? No silly, not me it's the > person who gives you a million dollars. But I have the answer > to your question/problem. I'm a fully Authorized Kenwood > and Pyramid Dealer and Service Station so I've seen this > question a few times... > > The tk-780 & tk-880 has two surface mount resistors that need > to be relocated to allow external audio through the kct-19 > cable (external input). > > And just to make life more enjoyable I'll now tell you > the Service Manual does describe those resistors when using > the KCT-19 but I know for a fact that most of the early > Service Manuals have the configuration wrong/backwards. So > once you get the two resistors moved over to the reverse of > what the Service Manual indicates, you also need to enable the > external path PTT in software. > > To enable PTT input on pin 8 of the KCT-19, under Edit/Optional Features, > program Com2 as "Aux Hook/PTT". > > Move the resistors, change the programming and the tk-780 radios > should start transmitting audio through the external kct-19 > input "port". > > You will probably need to have a copy of the Service Manual > to understand the mentioned resistor(s) locations and > configuration. > > that is all... > > cheers, > skipp > skipp025 at yahoo.com > www.radiowrench.com > > > > "phillmobile" <phillmobile@> wrote: > > > > Hello all i am working on interfacing a tk-780 with a > > gm300, which will be mounted in my car for crossband repeat > > > > so the problem is as follows when the gm300 rx the tk-780 > > tx but there is no audio or depending on the setting the > > mic on th tk works for audio so you key on a ht to the > > gm300 and speak in to the mic on the tk and it transmits > > that audio unless you have it disabled then you get no audio > > but i know that i am getting audio from the gm300 to the > > kct-19 i have tested it i have tried for hours and > > have tried a tk-880 too same issue i have tried both pin > > nine and pin five on the kct-19 and many hours checking > > and testing different switch settings in the software it > > just won't work but the other way back to the gm300 (uhf) works > > perfectly, so looking for some pointers, my references are > > the pyramid svr200 to kct19 wiring plan and the tk-780 > > service manual and its european so its kpg-60d > > any thanks in advance > > >
