Hi guys .I would like to know if other installers have run into the
following problem .Installing a collinear base antenna to mounting tube and
have turned the u bolts up too tight that the antenna either doesn't work or
cracking occurs in repeater .
One site I did, I installed a brand new uhf collinear and it had no range
and after inspecting it found nothing that I could see wrong .After
reinstalling it with a little less pressure on the clamps its working ok
with no worries.
The second one I have done works but crackles and I hope to check it today
I just wondered if anyone else has had this issue when installing repeater
antennas and worked out a suitable tension pressure that the u bolts can be
tighten too that doesn't cause any problems .
Thank You,
Ian Wells,
Kerinvale Comaudio,
361 Camboon Road.Biloela.4715
Ph 0749922449 or 0409159932 or 0749922574
www.kerinvalecomaudio.com.au
