To answer your questions. Yes, I did follow the PDF to the t. as well as the Moto manual. The coil preset was followed.
The channel element is putting out a clean signal. Not sure on the appropriate level? Have not found levels in the documentation to compare to. What I am thinking now, is the element is now so far towards the bottom of its usable frequency that it is unable to drive the exciter. --- In [email protected], Mike Morris WA6ILQ <wa6...@...> wrote: > > I have to ask - > > Did you follow the coil preset chart in the guide on > repeater-builder? > <http://www.repeater-builder.com/msr2000/pdfs/msr2000-uhf-tx-align.pdf> > > Are you sure the channel element is putting out a > clean signal? > > Is the multiplier chain putting out an appropriate level > on the test set? > > Mike > > At 08:47 PM 03/05/10, you wrote: > >Hello all. > > > >I have a UHF msr2000 exciter that does not want to play nice. > > > >It was working on its original frequency of 461.100 and drove the PA > >at 100 watts. > > > >I am trying to move it to 440.300 I have followed the steps in the > >Moto manual for peak and dip. peak and dip. done this about 6 times. > > > >The exciter only wants to put out about .1 mw of power. > > > >What am I missing? Is there a component change that I must do? Is > >the exciter not going to play? The exciter is a TLE5312 > > > >Thanks in advance. > >-Jason > > > > > > > >------------------------------------ > > > > > > > >Yahoo! Groups Links > > > > > > >
