Milt,
I have NTN5040A and NTN5596A fronts, which are DTMF.
--- In [email protected], "Milt" <men...@...> wrote:
>
> Make sure that you have DTMF fronts and not selectable MDC1200 fronts, IIRC
> they looked pretty much alike. The MDC ones had a protrusion at the top
> while the DTMF ones did not.
>
> Milt
> N3LTQ
>
> ----- Original Message -----
> From: <brown7...@...>
> To: <[email protected]>
> Sent: Monday, April 26, 2010 12:05 PM
> Subject: [Repeater-Builder] MT1000 DTMF programming
>
>
> > I have taken up programming MT1000's. I am having trouble getting some
> > radios that have DTMF to accept the fronts. I have several different model
> > fronts and have tried them all to no avail. Is there a specific procedure
> > to get the control module to recognize the DTMF front? I continually get
> > the message this radio front incapable of DTMF. Sometimes the program
> > version R03.01.02 states that a model ntn5697A front must be used. That is
> > an encode/decode front and hard to come by. As I understand it, these
> > radios should still be able to use the other fronts. I have tried the
> > continuous and short burst fronts with the same results. Can anyone help
> > me with this issue? Thanks... Ray
> >
> >
> >
> > ------------------------------------
> >
> >
> >
> > Yahoo! Groups Links
> >
> >
> >
>
