You will need to utilise the OPC-617 interface leads. With these you can
configure the radios as a "Basic Repeater".
Just a simple process of bringing out the DB9 sockets from the OPC-617 to a
common mating block with a trimmer pot between the audio out and mic in ports
for setting up line levels and tying the "Busy Out" to the "TX" line.
Just bear in mind that you are dealing with mobiles that exhibit little
selectivity and a very low TX duty cycle, so not the best choice to deploy in
RF dense locations and if you are planning to utilise the repeater in a high
duty cycle situation.
Cheers
Gareth Bennett
RadioSystems
P.O. Box 5202
Dunedin 9024
New Zealand
gare...@radsys.co.nz
----- Original Message -----
From: Harald A.Eriksen
To: Repeater-Builder@yahoogroups.com
Sent: Saturday, June 05, 2010 8:17 AM
Subject: [Repeater-Builder] Using IC-F1010 x 2 as repeaters???
hi.
Can our radiogrop use icom icf1010 as a repeater? Where can we get info
and connection equitment?
Thanks and best regards
la4vna, Harald
